Remove the mig gun cable and all from the welder.
Mig welder wire stuck in liner.
One of the most common problems with an mig welder is the welding wire becoming stuck in the welding gun.
To maximize the performance of your mig equipment choose the correct liner size for the wire being used.
Next remove the old liner and then feed in the new liner.
A metal inert gas mig welder uses a semi automatic arc welding process in which a continuous welding wire is fed through the welding gun forming a weld.
By switching liner and connection it helps to replace things worn and get back your job in quick time.
Depending on what machine you have just pull the liner out of the welding gun assembly.
There are a couple of different liners used in mig welding machines.
Once the new liner is in trim the liner to around 3 4 where it comes out of the neck of the weld gun.
Choose the right size.
The one you need is going to be determined by your mig wire.
Aluminum wire will require teflon liners.
Then remove the tip and nozzle.
You should then be able to remove the liner by pulling it out welder end of cable if not look for some type of set screw or fastener holding it in it could be at ether end.
Aluminum is soft enough to move very quickly through the line and offers less drag.
This lets the aluminum through more smoothly.
First remove the old liner along with the welding wire nozzle tip and diffusor.
Small diameter welding wires 023 in.
When the welding wire becomes stuck you must remove it or the welding gun can be.
If you switch off your device and the mig welder doesn t go off until you cut off the power supply it means merely your liner needs to switch out.
1 teflon liners for aluminum.